Feather and Teardrop Flags: Text and graphics should be placed at least 0.5" from the edge of the hem for safety. Artwork can be wrapped around the pole, but again keep important elements clear of the pole pocket seam and the hems.

Bleed: ensure you have 0.5" on all sides of your artwork, do not add crops.

Pole Flags: Text and graphics should be placed at least 0.5" from the edge of the hem for safety. 4over will professionally hand sew 0.5" hems around the Pole Flag.

Bleed: ensure you have 0.5" on all sides of your artwork, do not add crops.

Download and use our flag templates to ensure your artwork is set-up correctly.

4over's flags are printed using superior quality dye sublimation equipment on lightweight 3oz polyester. Pole Flags have an additional Reinforced Grommet Strip made of canvas on either the left or right side of the flag for wind resistance.

Yes, the 3oz polyester flag material is flame resistant under normal conditions. Avoid exposure to open flame and exceedingly high temperatures. Avoid exposure to strong oxidizers, bases, and acids.

No, the actual flag material is approximately 1.5 to 2 feet shorter than the height of the flag when assembled on the flag pole.

Feather Flags: shaped like a feather.

Teardrop Flags: shaped like a teardrop.

Pole Flag: rectangular flag.

Feather/Teardrop Flags have the option to include indoor or outdoor hardware. The flag material will be neatly folded and packed in a flexible bag. The hardware comes in a black travel bag. Both items will be carton packed together. Assembly is required. Click here to download the assembly guide.

Indoor - X-Stand/Cross base includes:

1. Flag pole

2. X-stand / cross base

3. Cord

4. Travel bag

5. Water tube (to stabilize the flag)

Outdoor - Ground-Stake/Spike base includes:

1. Flag pole

2. Spike base

3. Cord

4. Travel bag

Pole flags have the option to include 6ft Pole hardware with 2 position plastic wall bracket.

The hardware includes:

1. 6ft Pole

2. 2 position wall bracket

3. Wall mounting kit

The actual flag pole hardware is the height advertised, however the installed flag will be shorter depending on installation, stand type and the tension applied to the fabric and cord.

The difference between the jumbo and regular feather flag is the width of the flag.

• Feather Flag Jumbo is 34" wide
• Feather Flag Regular is 29" wide

Single sided flags will have transparency on the back side of the flag. Double sided flags will have two 3oz flags sewn together with a block-out material in the middle to avoid transparency.

Templates will be provided for the double sided flags. Please see the templates under feather and teardrop flags in our resource section.

Yes, the hardware is interchangeable between single and double sided flags.

This will be a new option offered for single sided flags. When placing a single sided flag (4:0) order, you will see the options “no sleeve” and “black sleeve”. “No sleeve” will give you our standard flag where the art will go to the edge of the pole. For an additional cost, you can add the black sleeve for reinforcing and increasing the durability of your flag.

Please note, double sided flags (4:4) will always have a black sleeve.

Yes. See chart below:

Yes. Please see our Flag Height chart below:

Yes, the indoor hardware includes a water bag which sits on the top of the cross base and adds weight and stability for outdoor use on hard surfaces such as concrete and asphalt. It is recommended that you test your specific application.

Option for white or black thread hemming is available.